Is it possible to get a tighter cut-in as I can't seem to perform the same cuts going back and forth between the T7 I have which is more tight vs. the T10. Is there a way to use the entire distance like mixers that have cut-in you can make it cut-in so tight that it brings it bleeds through by design which means the cut-in is way more tight. The cut in feature feels just like my Numark Scratch mixer's stock fader where I cannot get the same cuts in due to the cheap base model mini innofader that does not have a great cut-in until I upgraded to the Innofader Pro 3, then the cuts got way better while using the "innojuster". Is there anything that can be done either by a software update, or by installing another aftermarket crossfader in place like the Vyper Kitten by Jesse Dean, or even another better innofader?
Hello Scratchfade,
Please make sure you
1) set the cut lag with rotary button on the front, to set the dead zone,
2) and afterwards you calibrate the faders with the calibration process detailed on https://support.hercules.com/en/kb/1896-en/
