velocity pads

just upgraded my install of djuced40 to 2.084 and still using in conjunction with my rmx 2. funny thing but when i used my velocity pads for effects in the previous version i could use the velocity sensitivity to set the effect threshold. i can still do this, but now i need to hold the shift button down simultaneously. i’m sure this was not needed before i upgraded!?

anyone else noticed?

thanks

As far as I'm aware, this is always been the way:

- Pressing the pad activates or disables the effect

- Shift+ Pad modifies the effect parameter.

Must be my memory on-board memory that is at fault!  Thank you for the reply!