hi,
How should I connect my DJI Mic 2 to the Inpulse 500 so that it sounds 'good'? When I use a 3.5mm to 6.35mm adapter, I only start hearing something when I turn the volume all the way up — and then I immediately get feedback. If I pull the 3.5mm plug slightly out of the adapter, it works, but it's very unstable.
thanks for any advice!
grz ale
Hello Xelage86,
Welcome to the forum area.
1) 6.3 mm (1/4") Adapter on microphone input
I suspect your microphone output is stereo, then connecting a TRS connector makes a mess (TRS is perfect for a mono balanced microphone).
You should try a 6.3mm MONO adapter (TS) instead of a stereo adapter (TRS).
2) Dual RCA adapter on aux input
DJI Mic 2 user manual, at page 28, says "Max Input Level (3.5mm): -6dBV (THD < 0.1%)".
Input level is not clear for me as I see no schematics describing what it refers to, but if it means "output level" instead of "input level", then
- it is not a microphone level (it is too too loud, microphone input level is usually between -40dBv and -60dBv)
- it is a line level and it should work with DJControl Inpulse 500 Aux input, so you can try connecting it to the aux input with a dual RCA male to 3.5mm (1/8") stereo adapter
